Many books have been written about how to frame a house. There are many different ways to go about the task of house framing. Nearly every builder does it differently. That doesn’t mean that one builder is wrong or the other is right, they just have different methods to get to the same point, framing the house. The critical step in house framing is accurate measurements and cutting the material square.

DIY homeowners can frame a house, but it is a lot of tough physical work. The key to how to frame a house with a successful outcome is getting everything square, plumb, and level. If these three things are not done to near perfection your project will look more like the house that “Jack built” rather than the work of a professional carpenter. Here are some house framing tips to help the DIY home builder with framing a house.

House Framing Tips:

Before beginning become familiar with the building code in your area. There are many aspects of the code that deal with framing a house. Become aware of the span requirements, the notching and boring of floor joists and studs, construction of beams, support structures, stud spacing and the many other things dealing with framing. Although some of these requirements are obvious others are not.
One of the most important steps is to ensure that the joist layout, walls, and flooring are square. When the floor joists are square the installation of sub-flooring and walls is so much easier. And when the walls are square to the subflooring the wall sheathing, roof and roof sheathing task become much easier.
The floor plan of a house is almost always a combination of rectangles and squares that are bunched together. They all fit better when they are square with square edges that are 90 degrees to each other.
After the deck is finished, the subfloor installed on top of the joist, framing the exterior walls is the next step. The best method is to build them laying on the subfloor and covering them with the exterior wall sheathing as they lay flat and square. This will ensure that you have a straight wall. After they are constructed tilt them up and nail them in place. Bracing will be necessary to keep them in place as the joining walls are built, stood up and nailed to the deck and to each other. If you frame the walls square they will fit together perfectly.
Professional carpenters always stack the framing components. This means that the wall studs should line up directly above floor joists below. And the ceiling joist set directly on top of the upper plate above a stud below it. This is not always possible depending on the style and layout of the house. Stacking allows bearing loads to be transferred directly to the foundation. It also makes it easier to run utilities such as wiring and heat ducts. If there is a second story the floor joists of the second story need to line up directly above the first floor wall studs below whenever possible.
If you are totally new to house framing I suggest that you visit a construction site and talk to builders to get the overall jest of the process. In addition, pick up a DIY book on house framing. Most of them are very good and the directions are in accordance with the nation homebuilding code.
You can frame a house as DIY task by yourself but it is easier with a helper or two with the heavy lifting and making measurements. If possible hire a helper that has some house framing experience.

See More DIY Building Ideas and Suggestions